3. TEXT COMPU LINK connection
If you are using a JVC audio amplifier/receiver supporting TEXT COMPU LINK, connect either one of the TEXT COMPU LINK ports on the back of the unit with the amplifier/receiver’s TEXT COMPU LINK port using the supplied TEXT COMPU LINK cord (green).
|
| TEXT COMPU LINK |
OUTPUT | TEXT | DIGITAL cord (Green) |
(SYNCHRO) | COMPULINK | (OPTICAL) |
LEFT
RIGHT
To TEXT
COMPU LINK jack
By using the TEXT COMPU LINK system, you can see the disc information or search result on the TV monitor, as well as copy disc information to a MD, and more.
(See “TEXT COMPU LINK SYSTEM” on page 21.)
4. Power connection
Connect the supplied AC power cord into the socket on the back of the unit. Then insert the AC plug into an AC outlet. (If you use the COMPU LINK system, do not connect the AC plug into a switched AC outlet of a component.)
AC POWER CORD
AC power cord
AC outlet
Installing batteries in the remote control
The battery compartment is located on the back of the remote control.
1. Press down on the triangular mark of the compartment cover, and pull up the cover to open the compartment.
2. Set the two supplied batteries R6P
3. Place the cover over the compartment, and press down.
CAUTION
•Install the batteries with their polarities correctly set.
•Remove the batteries if the remote control is not going to be used for an extended period of time.
•Do not expose the remote control to heat, flame, or direct sunlight.
Replacing the batteries
The service life of batteries normally lasts for about one year though it depends on the use of the remote control (and is shorter at low temperatures, too). Replace the batteries any time if the controllable range is reduced (max. range: 7 meters or 23 feet and 30 degrees away from the unit).
CAUTION
•Be sure to replace them with the correct batteries
•Do not use a combination of new and old batteries.
3
