JVC XV-D721BK To connect to an audio equipment with a digital input, To connect the power cord

Getting started

To connect to an audio equipment with a digital input

You can enhance the sound quality by connecting the unit’s DIGITAL output (OPTICAL or COAXIAL) to the digital input of an amplifier, DAT or MD by using an optional digital cable. The digital audio signal from a disc is directly transferred. If you connect the unit to a Dolby Digital or DTS decoder or an amplifier with a built-in decoder by using an optional digital cable, you can enjoy high-quality surround sound.

When you make the digital connection, also make the analog connection, because, depending on the disc type, no audio may be reproduced from the DIGITAL outputs.

When using the DIGITAL OUT (OPTICAL) jack, remove the protection cap. Do not lose the removed cap.

When the jack is not used, fix the protection cap into the jack.

The unit
FRONT		CENTER
LEFT	LEFT
RIGHT	RIGHT
ANALOG		SUBWOOFER
	COAXIAL	VIDEO	S-VIDEO	Y	PB	PR
					COMPONENT
	AUDIO OUT	AV COMPU LINK				VIDEO OUT

Optical digital cable (not supplied)

SCAN MODE

525p 525i

Coaxial digital cable (not supplied)

Digital equipment

White	Red	White	IN	IN
			LEFT
	Audio cable		AUDIO	COAXIAL
			OPTICAL
			RIGHT
	(supplied)	Red	DIGITAL

•For digital connection, connect the unit’s DIGITAL output (OPTICAL or COAXIAL) to the digital input of an audio equipment using an optional digital cable.

NOTES

•When you connect the unit's DIGITAL output to a digital audio equipment, before using, make the “DIGITAL AUDIO OUTPUT” setting in the “PREFERENCE 2” on-screen display correctly according to the connected audio equipment. If the “DIGITAL AUDIO OUTPUT” is not set correctly, loud noise may be generated from speakers, causing damage to your speakers. See “DIGITAL AUDIO OUTPUT” on page 42.

•When you connect the unit's DIGITAL output to a Dolby Digital or DTS decoder (or amplifier with a built-in decoder) to enjoy surround sound, the unit's “COMPRESSION” setting in the “PREFERENCE 2” on-screen display and all settings in the “SPK. SETTINGS” display are invalid. Make appropriate surround audio settings by the decoder.

To connect the power cord

When all the audio/video connections have been made, insert the smaller plug of the supplied AC power cord to the unit’s AC IN connector, then insert the other end to the wall outlet. Make sure that plugs are inserted firmly. The STANDBY indicator lights and setup is completed.

Warning

•Disconnect the power cord if you are not going to use the unit for a long time.

•Disconnect the power cord before cleaning the unit.

•Disconnect the power cord before moving the unit.

•Do not connect or disconnect the power cord with wet hands.

•Do not pull the power cord when disconnecting it, as this may damage the cord and cause fire, electric shock, or other accidents.

Caution

•Do not damage, alter, twist, or pull the power cord, as this may cause fire, electric shock, or other accidents.

•To prevent any accidents or damages caused by an unsuitable AC power cord, only use the supplied power cord. If the cord is damaged, contact a dealer and get the new power cord.

•Do not put anything heavy, or the unit, on the power cord, as this may cause fire, electric shock, or other accidents.

16