JVC XV-N512S manual To set the speaker level, To generate test tone signals

5/∞

ENTER

To return to the [SPK.SETTING] page

Press 5/∞ to move to [RETURN] and press ENTER.

Hint

If there is no difference between the distance from the front speakers to the listener, and the distance from the center speaker and/or the surround speakers to the listener, select [0.0m].

If there is a difference between them, refer to the following diagram to set the delay time correctly.

			Subwoofer
				Center speaker
	Front speaker									Front speaker
	(L)									(R)
									3.0m
								2.7m
							2.4m
						2.1m
		Surround speaker (L)			Surround speaker (R)
	In the above example, set [CENTER SPEAKER] to [0.3m], and
	[SURROUND SPEAKER] to [0.9m].
	As the distance from the center speaker and/or the surround
	speakers to the listener is shorter than the distance from the front
	speakers to the listener, select the longer distance value.
	NOTE
settingsinitialtheChanging	This setting can only compensate for differences in speaker
	distance when the front speakers (left, right) are farther from the

listener than the other speakers.

To set the speaker level

You can adjust the output level of each speaker.

1	Bring up the SPK.SETTING menu.
2	Press 5/∞ to move	to [LEVEL] and press
	ENTER.

The [LEVEL] display page appears on the TV screen.

LEVEL
	FRONT SPEAKER	0dB
	CENTER SPEAKER	0dB
	SURROUND SPEAKER	0dB
	SUB WOOFER	0dB
	TEST TONE	OFF
	RETURN
SELECT	USE 5∞23 TO SELECT, USE ENTER TO CONFIRM
ENTER	TO EXIT, PRESS SETUP.

3 Press 5/∞ to select the speaker to be set and press ENTER.

FRONT SPEAKER: front speakers (This item cannot be selected. The level is fixed to 0 dB.)

CENTER SPEAKER: center speaker

SURROUND SPEAKER: surround (rear) speakers

SUB WOOFER: subwoofer

4 Press 5/∞ to set the level and press ENTER.

The selectable level ranges from –6 to 6 dB in 1 dB unit.

5 Repeat steps 3 and 4 if you want to set other speakers.

To return to the [SPK.SETTING] page

Press 5/∞ to move to [RETURN] and press ENTER.

NOTE

For the speaker(s) whose size is set to [NONE], the speaker level cannot be set.

To generate test tone signals

You can check the level setting by monitoring the test tone.

1 Press 5/∞ to select [TEST TONE] and press

ENTER.

2 Press 5/∞ to select [ON] and press ENTER.

The test tone will be generated when you select the speaker(s) in the [LEVEL] page.

NOTE

The test tone sound is not output from the subwoofer.

38