KiWi ClickDiscs
How to install and remove ClickDisc indexing discs
Assembly
1)Install the appropriate ClickDisc into the cavity on the top of the barrel. Be sure to orient the tab of the ClickDisc into the notch of the barrel. Push the ClickDisc into posi- tion.
2)Place the horizontal plate over the barrel and reinsert the axle. Make sure that the plastic washer is on the axle.
3)Push down on the knob of the axle to compress the as- sembly and to retract the spring plunger fully. As you apply pres- sure on the knob, use the set screw wrench to tighten and se- cure the axle in position.There should be no discernable play between the barrel and plate.
4)You may find it easier under certain circumstances to unscrew and retract the spring plunger just a bit. It will be easier to compress the assembly this way. Be sure to readjust the plunger afterwards.
Horizontal Plate
Barrel w/ClickDisc Installed
Set Screw Wrench
Axle w/Plastic
Washer
ClickDiscBarrel
Set Screw Wrench in Barrel
4
