Kambrook KOT630, K0T630 manual Removable Wire Oven Rack, Using the Top Element for Grilling

Using Your Mini Oven continued

Removable Wire Oven Rack

Always place the wire oven rack into the top, middle or bottom rack support guide in an upward rack return position. This offers three rack height positions.

Fig. 1

6.For grilling, place the food on the baking tray, and place inside the oven and onto the wire oven rack. Ensure that a separate timer is now activated if required in order to measure cooking duration.

NOTE: The mini oven does not have an inbuilt timer, so a separate timer will be required.

7.Leave the door slightly ajar, leaving a minimum 50mm gap at the top, rear and all sides of the oven. This will ensure adequate airflow during grilling.

8.Monitor the cooking to check if the food needs to be turned.

Using the Top Element for Grilling

Grilling is a fast way of cooking foods such as steak, lamb chops and sausages, as well as making toasties.

1.Ensure that the mini oven is on a dry, level, heat resistant surface. Make sure that the power outlet is switched off and that the mini oven is unplugged from the power outlet.

2.Open the glass oven door and position the wire rack into the top rack support guide inside the oven in an upward rack return position.

3.Select on the element selection dial.

4.Select the desired temperature according to the recipe on the temperature control dial.

5.Plug the mini oven into a 230V or 240V power outlet and switch the power outlet on. The heating light will illuminate.

9.When grilling has finished, remove the baking tray with oven mitts, and place the baking tray on a heat resistance surface.

Using the Bottom Element for Re-Heating

Re-heating allows pre-prepared meals to be enjoyed as they were intended to be.

1.Ensure that the mini oven is on a dry, level, heat resistant surface. Make sure that the power outlet is switched off and that the mini oven is unplugged from the power outlet.

2.Open the mini oven door and position the wire oven rack in the bottom or middle rack support guide in an upward rack return position, depending on the height of the pan used.

3.Select the element on the element selection dial.

8

KOT630_IB_B11_FA.indd 8 11/07/11 11:57 AM