HDS 2000 Super
4.
GB
4.7Connecting the water
•See technical data, chap. 3 for connected loads.
•Attach the supply hose to the appliance and to the water line. The supply hose is not included in standard delivery.
•If you draw in the water from an open tank, you should
–disconnect the water supply from the pump head
4.9Intended use
•Use the appliance to clean machines, vehicles, buildings, tools, etc.
•Clean facades, patios, garden implements, etc. with the
•If the machine is used at petrol stations or in other hazardous areas, the appropriate safety regulations must be observed.
–unscrew the upper supply hose from the water tank and connect to the pump head.
–use a water supply hose which has a minimum diameter of 3/4" and a suction filter.
•Until the pump has drawn in the water, you should:
–rotate the pressure and volume control to “MAX”,
–close the detergent metering valve.
•Please ensure waste water containing mineral oil
does not contaminate soil, lakes and rivers or the sewerage system. Therefore, please wash engines and underbodies only in appropriate washing installations provided with oil traps.
4.8Connecting the power
•See technical data, chap. 3 for connected loads.
•The voltage stated on the rating plate must correspond to the voltage of the power source.
•First, position the appliance switch to “STOP” and then put the electric plug into the socket.
•If the motor rotates in the wrong direction, the electronic control circuit will switch the motor off after a few seconds. The INCORRECT MOTOR ROTATION warning light illuminates.
Disconnect the power input plug. This plug is equipped with a device for reversing polarity. Apply a screwdriver at the prescribed point, press it inwards and rotate both terminals through 180°.
Attach the power input plug again.
•If you are using an extension lead, it should always be completely unwound from the cable drum and have an adequate
Mains voltage | 10 m | 30 m |
230 V | 6 mm² | 10 mm² |
400 V | 4 mm² | 6 mm² |
21
