K1400 electric 6/27/02 6/27/02 10:01 AM Page 6
OPERATING INSTRUCTIONS – continued
|
|
|
|
|
|
|
|
|
|
High pressure | High pressure | Rotating jet for | Low pressure | |
pencil jet | fan jet clean- | maximum dirt | Fan jet | |
cleaning | ing | cutting action | for detergent | |
|
|
|
| injection |
|
|
|
|
|
Step 5 Turn Quattro Nozzle to desired setting position. Match symbols above.
WORKING WITH DETERGENTS
Detergents can only be applied at low pressure
Step 1 Install the Wash brush or Quattro nozzle.
For best results see Cleaning Tips on pages 8 & 9 or included clean- ing guide for specific information on how to clean different surfaces.
Always Use Kärcher Detergents for Best Results.
Kärcher biodegradable detergents are specially formulated to protect the environ- ment and your pressure washer. The special
WARNING
RISK OF INJECTION OR INJURY- DO NOT DIRECT DISCHARGE STREAM AT PERSONS.
Step 2 Fill a container with Kärcher detergent. Place the filter end of detergent suction tube into the container.
formula won’t clog the suction tube filter and will protect the internal parts of the pressure washer for a longer life. For Kärcher Detergents, check your retailer or call:
5
Step 6 Turn on the pressure washer. The motor starts only if the trigger of the gun is pulled and shuts off when the trigger is released.
TO AVOID SERIOUS INJURY, NEVER POINT SPRAY NOZZLE AT YOURSELF, OTHER PERSONS OR ANIMALS.
6
In USA Call:
or visit our website:
The following Kärcher detergents are available:
LIQUIDS | TABLETS |
(ready to use) | (concentrated) |
Vehicle Wash | All Purpose |
House Wash | Degreaser |
GFCI INSTRUCTIONS
Step 3 Turn on the pressure washer. Pull trigger to operate unit: Liquid detergent is drawn into the unit and mixed with water. Apply detergent to work area. Do not allow detergent to dry on surface.
Degreaser | Deck and Patio |
Deck Wash | Windows and Siding |
All Purpose Cleaner |
|
Vehicle Wax |
|
Step 1 Plug the Ground Fault Circuit Interrupter (GFCI) into a working outlet.
Note:
The actual appearance of the GFCI may be different from this illustration.
Step 2 Press “TEST”, then press “RESET” to assure proper connection to power.
Caution
Never use:
•Bleach, Chlorine products and other corrosive chemicals
•Liquids containing solvents
(i.e., paint thinners, gasoline, oils)
•
•Ammonia products
•
These chemicals will harm the unit and will damage the surface being cleaned.
