Switching the server on and off | Starting up and operation |
–System already installed:
ÊPress the On/Off button (see figure 13 on page 64).
The server is switched on, performs a system test and boots the operating system.
Switching the server off
The
ÊShut down the operating system properly.
The server is switched off automatically and goes into standby mode. The
IIf the operating system does not switch the server off automatically, press the On/Off button for at least four seconds and/or send a corresponding control signal.
Other On/Off options
Besides the On/Off button, the server can be switched ON and OFF in the following ways:
–Timer-controlled switch-on/off
Using the ServerView Operations Manager or iRMC S2, you can configure that the server is switched on/off controlled by timer.
–Ring indicator
The server is switched on by an internal or external modem.
–Wake up On LAN (WOL)
The server is switched on by a command via the LAN (Magic PacketTM).
–After power failure
The server automatically reboots following a power failure (depending on the settings in the BIOS or in iRMC S2).
–Power button override
The system can be switched off by pressing and holding down the On/Off button (for approximately 4 - 5 seconds).
76 | Operating Manual | RX600 S5 |
