Fujitsu RX600 S5 manual Removing a hot-plug expansion card

CSS components Hot-plug components

8.1.4.1Identifying the defective CSS component

ÊOpen the server (see "Opening/Closing the server" on page 134).

ÊPress the Indicate CSS button on the system board (see Technical Manual for the system board D2870 on the ServerView Suite DVD 2).

The PRIMERGY Diagnostic LED of the defective CSS component lights up orange, thereby indicating which CSS component on the system board must be replaced (see Technical Manual for details).

8.1.4.2Removing a hot-plug expansion card

ÊIf required by the operating system, start the PCI hot-plug software. You will find information about this in the readme file on the ServerView Suite DVD 2).

Figure 28: Deactivating, unlocking and removing the board

ÊDeactivate the expansion card using either the relevant PCI hot-plug software or by pressing the light-pipe switch (1).

ÊWait until the light-pipe switch (1) no longer lights up. The slot is now zero potential.

ÊIf necessary, remove all cables from the expansion card.

ÊOpen the expansion card lock by lifting it up (2).

RX600 S5 Operating Manual 109