Hot-plug components

CSS components

8.1.4.3Removing a dummy module

If a slot does not contain an expansion card, it is occupied by a dummy module. This is a retaining plate with an attached removal tool.

Before inserting an additional hot-plug expansion card, you will first have to remove the dummy module from its slot.

ÊOpen the server (see "Opening/Closing the server" on page 134).

ÊRemove the dummy module in the same way as a PCI board (see figure 29 on page 110).

Removing the retaining plate from the removal tool

VCAUTION!

When removing the retraining plate from the removal tool, pay particular attention to the engaging hooks that fasten it to the removal tool. Never lift the engaging hooks by more than approx. 1 mm, in other words only as far until the retaining plate is released. Otherwise you could damage the engaging hooks.

Figure 31: Removing the retaining plate from the removal tool

ÊLift the green engaging hooks (see arrows) no more than approx. 1 mm until the retaining plate is released.

112

Operating Manual

RX600 S5

Page 112
Image 112
Fujitsu RX600 S5 manual Removing a dummy module, Removing the retaining plate from the removal tool