CSS components | |
|
|
|
|
Figure 26: Installing the 2.5-inch HDD module
ÊCarefully push the HDD module into the empty slot (1) until it stops.
ÊPush the handle completely (2) in the direction of the arrow until the locking mechanism engages.
8.1.3.4Removing the HDD module
VCAUTION!
●Only remove an HDD module during operation if the drive is not currently being accessed. Observe the control LEDs for the corresponding HDD modules (see "Indicators on the
●Under no circumstances should you remove an HDD module while the system is in operation if you are not sure that the hard disk drive is operated by a RAID controller and belongs to a disk array that is operating in RAID level 1, 1E, 10, 5, 50, 6 or 60.
An HDD module can only be replaced during operation in conjunction with a corresponding RAID configuration.
●All HDD modules (drives) must be uniquely identified so that they can be reinstalled in their original mounting locations later. If this is not done, existing data can be lost.
If you want to remove an HDD module during operation, proceed as follows:
RX600 S5 | Operating Manual | 105 |