| CSS components |
●If a memory module is installed and you pull the lever strongly outwards, the memory module pops up. Doing so may cause a device failure.
●Please observe the safety information in chapter "Important information" on page 27.
ITo guarantee that all memory modules in the relevant storage mode have identical characteristics, you must always replace 4 memory modules on each memory board. The only exception is memory boards running in spare mode or in independent mode - these only require 2 memory modules to be replaced.
For more information on the individual storage modes, see the Technical Manual "System Board D2870 for PRIMERGY RX600 S5".
Figure 35: Removing a memory module
ÊPress the holders on either side of the memory slot concerned outward (1).
ÊPull the defective memory module out of the slot (2).
118 | Operating Manual | RX600 S5 |
