Kathrein UFD 231, 260376 Programming Radio Programs, Programming radio programs

PROGRAMMING RADIO PROGRAMS

The satellite receiver has been preprogrammed in the factory.

The predefined programs are all listed on pages 6 to 9 (German)!

More and more new programs are continually be- ing transmitted via the satellites. To program-in these new programs you can obtain the necessary receiving parameters from current satellite maga- zines. If you already have a TV satellite receiver you can also call up the satellite transponder as- signments (satellite channels) via the program "SAT 1" videotext from page 516.

Programming radio programs

The setting of new programs is carried out:

-manually only for analog radio programs.

-manually or via search for digital radio pro- grams (ADR and DMX)

With manual programming of radio programs the following program parameters are to be set up:

·Satellite receiving frequency

·Polarization

·Orbit position

·Video deviation

·Oscillator

·Audio mode

·Audio frequency

·Audio de-emphasis (for analog progr. only)

·Program names (for analog progr. only)

Call the setup menu

(example for analog radio program)

Press	MODE + RADIO
in succession

ß

Display readout: RADIO-PROGRAM

entry	→ [OK]
ß
Press	ok
ß

The first menu entry appears in LCD display:

Display readout:	SAT-FREQUENCY
	11214 MHz

ß

Activation of first menu entry

with	ok
	ß

Display readout:	SAT-FREQUENCY
<	11214 MHz >

The setting can now be made.

ß

Input of the new satellite frequency

with the numeric keys	0...9
or the keys

When setting further program parameters the fol-

lowing applies:

ÞStep on to further menu entries with the keys

Þ Activate the menus with	ok
Þ Setting of parameters with	or with

the numeric keys for frequency inputs.

Explanation of the individual menu entries:

Satellite frequency:

·The frequency value is entered using the nu- meric keys as a 5-digit number in the range 10700 to 12747 MHz

·You can carry out an optimization of the re-

ceiving frequency using the -keys.

Polarity:

·The satellites beam down their programs with varying polarization.

·Set up the required polarity as either V or H. Here vertical corresponds to V = 14 V and hori- zontal to H=18 V LNB supply voltage.

·The additional setting possibilities "High" and "Low" are intended for future control possibili- ties in conjunction with "DiSEqC"-matrices. In this case a different setting is chosen for the initial setting in the "DiSEqC" menu.

·For standard receiving equipment you do not need to pay any attention to High and Low.

Orbit position

If you have a multifeed receiving installation for re- ception of several satellites e.g. Astra and Eutelsat, assign each satellite to an orbit position, e.g. Astra "orbit position 1" and Eutelsat "orbit position 2". Take into account preprogrammiing in the initial setup menu

Deviation

Set the video deviation to 16 MHz for reception of Astra programs and to 25 MHz for reception of Eutelsat programs.

18