Installation Menu
| In this menu you can run the scan. | |
| 1) | AutoScan |
|
| All channels in the 177 to 858 MHz frequency range are |
|
| scanned for programmes. |
| 2) | Net Scan |
|
| The complete network is scanned for network information |
|
| (The result only appears if the information is broadcast by the |
|
| provider). |
| 3) | TP Scan |
|
| This can be used to locate specific channels. |
| 4) | PID |
|
| Enter audio and video PID for detailed searching for specific |
|
| channels. |
| 5) | Scan Mode |
|
| Select the scan: All or FTA |
|
| you scan for all programmes, all programmes will be stored, |
|
| including the encrypted ones; otherwise only the FTA |
|
| programmes are stored. |
| Channel search: | |
Note: | In addition to displaying the reception strength and quality, the | |
| receiver also features an | |
| adjusting the antenna. It can be activated in this menu using the | |
| Mute button. | |
| Press the red button to start scanning the complete frequency range. | |
| The receiver asks you if you want to delete the existing channels. | |
| If you answer «Yes», all the assigned channels are deleted and | |
| the new setup is placed on the main list (in the order of the factory | |
| ||
| If you answer by pressing «EXIT», the scan is not started. | |
Note: | If you are in a catchment area covered by two | |
| it may be that the AutoScan causes some programmes to be | |
| duplicated in your channel list. You can simply leave them, | |
| or you can choose to use the channel offering the best picture | |
| (reception) and delete the other one. | |
Press the green button to scan for a specific channel. The channels found are placed at the end of the channel list.
PID (Programme Identification) input:
Press the yellow button. Key in the video and audio PID, and press the yellow button again. The channel is placed at the end of the main list, tagged «TV CH».
22
