Kathrein UFE 371/S Installation Menu, AutoScan, Net Scan, TP Scan, Scan Mode, Programme Scan

Models: UFE 371/S

1 36
Download 36 pages 38.93 Kb
Page 21
Image 21
AutoScan

Installation Menu

 

In this menu, you can carry out the programme search.

 

1)

AutoScan

 

 

All channels in the range of 177 MHz to 858 MHz are

 

 

searched for programmes.

 

2)

Net Scan

 

 

The entire network is searched for network information.

 

 

(Results only if this information is transmitted with the

 

 

programmes).

 

3)

TP Scan

 

 

Search for individual channels.

 

4)

PID

 

 

Enter audio and video PID for a detailed search for individual

 

 

programmes.

 

5)

Scan Mode

 

 

Selection of: All or FTA (free-to-air programmes only) – when

 

 

you run a programme search for all programmes, all

 

 

programmes are stored, including the encoded transmitters;

 

 

otherwise, only the free programmes are stored.

 

Programme Scan:

Note:

In addition to the indicator of reception intensity and reception quality,

 

the receiver has an assist function with a acoustic signal for adjusting

 

the antenna, you can activate in this menu by pressing the Mute key.

 

With the red key you can start the programme search for the entire

 

frequency range. The receiver prompts you to confirm that you wish to

 

delete the existent programmes. If you confirm with «JA», all the

 

allocated programmes are deleted and the new programming entered

 

in the main list (in order of the factory-set pre-programming at the

 

factory).

 

If you select «EXIT», the programme search will not be started.

Note:

Should you be in the catchement area of two DVB-T networks, it

 

may happen that you find some channels twice in your

 

programme list after you run the “AutoScan”. You can leave them

as they are, or you can decide in favour of the programme which provides the better image (reception), and delete the other one.

Start the scan by pressing the green key for a specific channel. The programmes that are found will be added on the end of the programme list.

PID (Programme Identification) input:

Press the yellow key, enter the video PID and the audio PID, and press the yellow key again. The programme, identified with «TV CH», will be placed at the end of the main list.

21

Page 21
Image 21
Kathrein UFE 371/S manual Installation Menu, AutoScan, Net Scan, TP Scan, Scan Mode, Programme Scan