INSTALLING DRILL BIT INTO KEYLESS CHUCK
VARIABLE SPEED TRIGGER SWITCH
WARNING
Before inserting a drill bit or other accessory, make sure the forward/reverse and trigger lock lever is in the center “OFF” position to prevent accidental starts that may result in injury.
Do not attempt to tighten drill bits (or any other accessory) by gripping the front of the chuck and turning the tool on. This may cause personal injury and/or damage to the chuck.
When removing the bit from the tool, avoid contact with skin and use proper protective gloves when grasping the bit or accessory. Accessories may be hot after prolonged use.
THIS TOOL IS CONTROLLED
BY A TRIGGER SWITCH:
•The speed of the Cordless Drill depends on the amount of pressure you put on the trigger.
•The more pressure you apply, the faster the Cordless Drill will go.
•Release the pressure and the Cordless Drill will slow down.
TRIGGER 
SWITCH
LED LIGHT
BUILT IN LED LAMP
1.Hold the rear end of the chuck in one hand and use the other hand to rotate the front end in a counter- clockwise direction to open the jaws of the chuck.
2.Insert the shank of the bit (or other accessory) fully into the keyless chuck, taking care to keep the bit in the center of the jaws of the chuck.
HOLD HERE
RELEASE
GRIP
HOLD HERE
•Press the trigger switch to light up the lamp. The lamp remains on while the trigger switch is being pressed. The lamp goes out after releasing the trigger.
NOTE: Use a dry cloth to wipe the dirt off the lens of lamp. Be careful not to scratch the lens of lamp, or it may lower the illumination.
Do not look into light or see the source of light directly.
FORWARD / REVERSE AND TRIGGER LOCK LEVER
3.Turn the front end of the chuck clockwise to hold the bit in place.
4.Tighten securely by turning the front end of the chuck clockwise while holding the rear end.
OPERATING THE DRILL
Be sure the trigger is released when changing the position of the lever. Always store the tool in the “LOCKED/OFF” position.
Always check the direction of the Cordless Drill's rotation before use.
Never tape the trigger switch down to provide continu- ous high speed. The tool may fail under such conditions causing fire or
personal injury.
TO SELECT THE DIRECTIONS OF ROTATION:
•To select forward Cordless Drill rotation, press the trigger lock from left to right flat against the Cordless Drill body.
•To select reverse, press the trigger lock lever in the opposite direction.
•The center position locks the tool.
| FORWARD |
| LOCK |
TRIGGER | REVERSE |
LOCK |
|
13
