Connecting to the mains / Switching ON and to standby

Connecting to the mains

After connecting all desired equipment as described, you can connect the Media Center to a wall socket.

1 Make sure all connections have been made before con- necting the Media Center to the mains supply.

2 First connect the mains lead to the AC-INPUT (9) and then to a wall socket.

> The Standby/On indicator (on the STANDBY-ON key 1) lights up orange.

>The Media Center is now in low power mode, consuming only a minimum amount of power.

Switching ON

To switch on the Media Center from low-power mode, press the y STANDBY-ONkey (1) on the front of the Media Center.

> The Standby/On indicator (1) goes out.

Press the y STANDBY-ONkey (1) again to put the Media Center back to low-power mode.

Switching to standby

When the Media Center is switched on (Standby/On indicator out), press the y Standby key (1) on the remote control to place the Media Center in standby mode.

>The Standby/On indicator (1) lights up red.

To switch the Media Center on again from standby mode, press the y Standby key (1) on the remote control again or the y STANDBY-ONkey (1) on the front of the Media Center.

>The Standby/On indicator (1) goes out.

Note: In both low-power and standby mode the Media Center is still consuming some power.To disconnect the Media Center from the mains supply completely, disconnect the mains lead from the wall socket.

17

Page 17
Image 17
Philips MCP9360I/22 manual Connecting to the mains / Switching on and to standby, Switching to standby