Kawasaki J8472, K0450 Assembly, or help in assembly of the vehicle, Battery, Charger Connector

B

Battery

A

Charger

Connector

•Plug the charger connector into the battery A .

•Plug the charger into a standard wall outlet B .

Notes:

-Use the charger only in a wall outlet. Do not plug the AC adaptor into a ceiling outlet.

-If power flow to the wall outlet is controlled by a switch, make sure the switch is “ON”.

•Before first-time use, charge the battery for at least 18 hours. Never charge the battery longer than 30 hours.

•Recharge the battery for at least 14 hours after each use of your vehicle. Do not charge the battery longer than 30 hours.

•Once the battery is charged, disconnect the charger connector from the battery. Unplug the charger from the wall outlet. The battery is now ready to be installed in your vehicle. Please see the Battery Installation section on page 15 for detailed instructions on installing your battery. If your battery is already installed in your vehicle, simply re-connect the motor harness connector to the battery.

ASSEMBLY

WARNING

Children can be harmed by small parts, sharp edges and sharp points in the vehicle's unassembled state, or by electrical items. Care should be taken in unpacking and assembly of the vehicle. Children should not handle parts, including the battery,

or help in assembly of the vehicle.

Rear Axle

Cotter Pin

1

• Fit a cotter pin into the hole near one end of the rear axle.

8 J8472pr-0920