Steering Column
Connectors
6 | BACK VIEW |
•Turn the vehicle upright.
•Fit the handlebar steering column and both connectors down through the large opening in the front end of the vehicle.
Steering Column
7 | BOTTOM VIEW |
•Lift the front end of the vehicle up slightly. Check to be sure the steering column fits through the hole in the steering linkage. Lower the front end of the vehicle.
•Push down on the handlebar assembly to “snap” it in place.
Steering Column Cap
8
•While holding the handlebar in place, carefully turn the vehicle over.
•Again, make sure the end of the steering column is through the hole in the steering linkage.
•Fit the steering column cap onto the end of the steering column.
•Insert a #8 x 3/4" screw through the large opening in the steering column cap and into the hole in the steering column. Tighten the screw.
Plate
9
•Slide the plate under the steering column, as shown.
•Insert a #8 x 3/4" into the plate and tighten.
10 |
