Kawasaki K0450, J8472PR Battery Installation, Seat, Battery Retainer, Power Wheels, Volt Battery

BATTERY INSTALLATION

IMPORTANT! Use only a Power Wheels® 12 volt lead-acid rechargeable battery. Use of any other battery will damage your vehicle. Make sure that you charge the battery for at least 18 hours using the enclosed Power Wheels® 12 volt charger before operating your vehicle for the first time. Charge the battery for at least

14 hours after each use of the vehicle. Never charge the battery longer than 30 hours. Failure to follow these instructions may damage your battery and will void your warranty.

Seat

Battery Retainer

3

•Carefully lower the battery into the battery compartment. The battery retainer slides over the battery to secure it.

1

•Press the tab under the back edge of the seat and lift to remove the seat.

Power Wheels®	Battery
12 Volt Battery	Retainer

A

Seat

B

4

Drive Buttons

Motor Harness

Connector

2

•Lift the battery retainer to access the battery compartment.

•Place the battery upright in the battery compartment.

•Plug the motor harness connector into the battery. Push firmly.

•Fit the tab at the front of the seat into the slot near the drive buttons A .

•“Snap” the tab at the back of the seat into the slot near the rear of the vehicle B .

15 J8472pr-0920