Kenmore 110.4472, 110.4418 manual Yourwashercanbeinstalledabasement,laundryroom

Additional spacing should be considered for ease of installation and servicing.

SelectingtheproperlocationforyourwasherimprovesAdditional clearances may be required for wall, door and floor

performanceandminimizesnoiseandpossiblewasher"walk." moldings.

Yourwashercanbeinstalledabasement,laundryroom,		Additional	spacing of 1" (2.5 cm) on all sides					of the washer is
closet,orrecessedareaSee"DrainSystem.	."	recommended		to reduce noise		transfer.
IMPORTANT:Donotinstallorstorethewasherwhereitwillbe		If a closet	door	is installed, the		minimum	air	openings in the
exposedtotheweather.		top and bottom		of the door are required.			Louvered doors with
Properinstallationisyourresponsibility.		air openings in the top			and bottom are acceptable.
Youwillneed:		• Companion	appliance		spacing	should also be considered.

•Awaterheatersettodeliver120°F(49°C)watertothe

washer.

•Agroundedelectricaloutletlocatedwithin5ft(1.5m)of

wherethepowercordisattachedtothebackofthewasher.

See"ElectricalRequirements."

•Hot and cold water faucets located within 31/2ft (1.1 m) of the

hot and cold water fill valves, and water pressure of 5-100 psi (34.5-690 kPa).

•A level floor with a maximum slope of 3A"(1.9 cm) under entire washer. Installing the washer on carpeting is not recommended.

•A sturdy floor to support the washer weight (washer, water and load) of 260 Ibs (118 kg).

Do not store or operate your washer in temperatures at or below 32°F (0°C). Some water can remain in the washer and can cause damage in low temperatures. See "Washer Care" for winterizing information.

Recessed area or closet installation

The dimensions shown are for the recommended spacing allowed, except the closet door ventilation openings. The dimensions shown for the closet door ventilation openings are the minimum required.

							3"
				14" max,
				_	48 in._	/-'_	(7"6 cm)
17,T					(310cm2) -
(43.2__
	I
	I
	)
					(155cm_)
	)						3"
0"-'--),,_ 22'/2".=->-{_-o_ -_11_-				24"	"->-14"l_-		__(7.6 cm)
(Ocm)	(57.2crn)	(Ocm) (2.5cm) (61cm) (10.2cm)
				B			C
		A. Front		view
		B. Side	view
		C. Closet door with vents

E(ectricaI Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Faimure to follow these instructions can result in death, fire, or emectrica{ shock.

A 120-volt, 60-Hz., AC-only, 15- or 20-amp, fused electrical supply is required. A time-delay fuse or circuit breaker is recommended. It is recommended that a separate circuit serving only this appliance be provided.

This washer is equipped with a power supply cord having a 3 prong grounding plug.

To minimize possible shock hazard, the cord must be plugged into a mating, 3 prong, grounding-type outlet, grounded in accordance with local codes and ordinances. If a mating outlet is not available, it is the personal responsibility and obligation of the customer to have the properly grounded outlet installed by a qualified electrician.