1.Drapethepowercordovertheconsole.

2.Movethewashertoitsfinallocationandremoveany cardboardusedtomovewasher.

3.Locatethebeadedtiestrap(supplied).

Beaded Tie Strap

4.Wrap the drain hose to the laundry tub leg or standpipe with the tie strap. (See illustrations A and B.)

BC

If the washer faucets and the drain standpipe are recessed, put the hooked end of the drain hose in the standpipe. (See

illustration C.) Tightly wrap the tie strap around the water inlet hoses and the drain hose.

Do not force excess drain hose back into the rear of the washer.

Properly leveling your washer prevents excessive noise and vibration.

1.Move washer to final location.

2.Check that the washer is level.

Check side to side and front to back by lining up the level as shown in the following illustration.

3.If the washer is not level, prop up the front of the washer with the wood block and adjust the feet up or down as necessary. If the washer is against a wall, move the washer out slightly before tipping back. Repeat this step until washer is level.

1.Check the electrical requirements. Be sure that you have the correct electrical supply and the recommended grounding method. See "Electrical Requirements."

2.Check to be sure all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped.

3.Check to be sure you have all of your tools.

4.Dispose of/recycle all packaging materials. Keep the expanded foam plug for use if the washer should be transported.

5.Check to be sure the water faucets are on.

6.Check for leaks around faucets and inlet hoses.

Electrical Shock Hazard

PJug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,

fire, or electrical shock.

7.Plug into a grounded 3 prong outlet.

8.Read "Washer Use."

g. To test your washer, measure and add 1/2the normal recommended amount of detergent to the washer. Close the lid. Select any cycle, and then press START/OFR Allow it to complete one whole cycle.

10

Page 10
Image 10
Kenmore 110.4472, 110.4418 manual Drapethepowercordovertheconsole