Optional exhaust installations

This laundry center can be converted to exhaust out the right or left side. To convert the laundry center, use Side Exhaust Kit Part Number 279823. If your laundry center was previously exhausted from the right or left side, it can be converted to rear exhaust by using standard offset connections. To cover the hole in the side, one of the following plugs can be added:

692790 (white)

3979370 (graphite)

3977784 (biscuit)

Follow the instructions in the kit to install. Kits are available from your local Sears store or Sears Service Center.

Over-the-Top Installation:

Part Number 26-49900

Periscope Installation (For use with dryer vent to wall vent mismatch):

Part Number 26-49901 - Less than 5" (12.7 cm) mismatch

Part Number 26-49908 - 5" (12.7 cm) to 18" (45.7 cm) mismatch

Part Number 26-49904 - 18" (45.7 cm) to 29" (73.7 cm) mismatch

Part Number 26-49905 - 29" (73.7 cm) to 50" (127 cm) mismatch

Special provisions for mobile home installations

The exhaust vent must be securely fastened to a noncombustible portion of the mobile home structure and must not terminate beneath the mobile home. Terminate the exhaust vent outside.

A. Standard rear offset exhaust installation

B. Rear exhaust for offset close clearance connection

C. Left or right side exhaust installation

Alternate installations for close clearances

Venting systems come in many varieties. Select the type best for your installation. Three close-clearance installations are shown. Refer to the manufacturer's instructions provided with the vent system.

....r:: ::_-- ....i-v:__-- -

Determine vent path

•Select the route that will provide the straightest and most direct path outdoors.

•Plan the installation to use the fewest number of elbows and turns.

•When using elbows or making turns, allow as much room as possible.

•Bend vent gradually to avoid kinking.

•Use the fewest 90 ° turns possible.

Determine vent length and elbows needed for best drying performance

""	(	"\,	i
X	(		X"

ABC

A. Loop system with standard elbows

B. Loop system with one offset and one standard elbow

C. Vent system with one periscope (2" [5 cm] clearance)

NOTE: The following kits for close clearance alternate installations are available for purchase. To order, please call 1-800-4-MY-HOME ® (1-800-469-4663).

•Use the Vent system chart below to determine type of vent material and hood combinations acceptable to use.

NOTE: Do not use vent runs longer than those specified in the Vent system chart. Exhaust systems longer than those specified will:

•Shorten the life of the dryer.

•Reduce performance, resulting in longer drying times and increased energy usage.

The Vent system chart provides venting requirements that will help to achieve the best drying performance.

Kenmore 110.88732 Optional exhaust installations, Alternate installations for close clearances

Models: 110.88732