EMPTY RECOVERY TANK
Unplug carpet cleaner from electrical outlet.
Automatic "shut off"
When the recovery tank (lower tank) is full, the automatic
The carpet cleaner will no longer pick up dirty solution and the motor sound will become noticeably higher in pitch.
When this happens, turn carpet cleaner off and empty recovery tank before continuing use.
Check the solution tank also; it may need to be refilled.
Never use unit w{thout the orange float or float retainer, located in the recovery tank, in place. If broken or dislodged, take to a Sears Parts and Repair Center for repair.
_Release latches (A) located on either side of recovery tank (B) by pushing latch toward rear of
carpet cleaner.
_Slide tank (B) straight out and carry it to a sink or drain. Remove lid.
_Empty tank through opening (C). To remove any debris that has collected on the lint screen (D),
flush with water.
Check to be sure that the orange float and float retainer, located in the recovery tank, are in pmace. If broken or dislodged, take to a Sears Parts and Repair Center for repair.
_Reposition lid by aligning hinges (E) at rear of tank. Press down on front of lid to secure in
place. Replace tank.
Push latches (one on each side of tank) toward front of carpet cleaner to lock tank in place. Be sure both sides are properly latched.
ON/OFF PEDAL and
HANDLE RELEASE PEDAL
_Step | on pedal | (A) to turn carpet cleaner on. |
| Step on pedal | again to turn carpet cleaner off. |
Step on pedal (B) to lower handle to operating position. Handle does not Jock into a singJe position but "floats" to alJow convenient operation.
14
