| MOTOR SAFETY FILTER CLEANING | l |
|
| |
_, WARNING | Remove the dust bag as outlined in the DUST |
|
BAG REPLACEMENT section, |
|
Electrical Shock Hazard
Unplug power cord from electrical outlet, Do not operale the vacuum cleaner without the motor safely filler. Be sure the filter is dry and properly installed to
prevent motor failure and/or electrical shock,
If the filter_ located in the bottom of the dust bag chamber_ is dlrty_ remove it by pul]lng forward out from under the ribs,
Wash the foam filter in warm soapy water, rinse and dry thoroughly by squeezing the filter in your hand and letting it air dryf
iiiii | iii iiii | i |
MOTOR SAFETY FILTER
Check motor safety
filter frequently and clean when
dirty°
Filler Cover
Molar Safety
Filler
DO NOT wash in the dishwasher.
DO NOT install damp,
Replace the foam filter by sliding it back into
place under the ribs in the dust bag chamber,
Replace the dust bag as outlined in the DUST
BAG REPLACEMENT section,
EXHAUST FILTER REPLACEMENT | ] |
|
The HEPA exhaust filter must be replaced
when dirty. It should be replaced
regularly depending on use conditions_
The filter CANNOT be washed as it will lose its dust trapping ability.
Note: See PARTS AND FEATURES for the exhaust filter number.
1o Remove exhaust filter
cover by
pressing the release tab on
the cover and
rotating out from vacuum
cleaner_
2, Remove the
filter cartridge from cover.
3.Place new filter cartridge into cover making sure that airflow arrow on side of cartridge points into cover_
Place foam seal of filter against the vacuum cleaner body°
Exhaust
Filter
Seal Against
Vacuum Cleaner
4.Replace the exhaust filter cover by placing bottom tabs in slots and rotating in until cover snaps into place,
1B
