Install Ignitor Battery
[] Unscrew the ignitor Cap from Control Panel.
[] Place supplied AA battery into the Ignitor Slot with positive pole facing you.
[] Position the Cap and Spring over the AA
battery and tighten onto Control Panel.
Main Burners Electrode Check
Perform this Electrode Check with the
assistance of another person.
This test will ensure that the Spark Electrode Tips are properly positioned so your grill lights easily and properly.
Spark Gap | Gas Collector Box | Inside Nut |
AA BATTERY
IGNITOR | CAP_ | j_ |
SPRING
IGNITOR
SLOT
Spark Receiver Spark Electrode Tip
[] | Be | sure | all | Control |
| Knobs | are | set | to | |||||
| "OFF" |
| and | open | the | Grill | Lid. |
|
| |||||
[] | Have | your | assistant |
| stand | behind | and to | |||||||
| the | right | of | the | grill |
| facing | toward | the | |||||
| front | of | the | grill | bowl. | Never | put | your | ||||||
| face inside the Grill Bowl. |
|
|
| ||||||||||
[] | Press | the |
| Ignitor | Cap. You | should | hear | |||||||
| a | "clicking" |
| sound. | Your | assistant | should | |||||||
| see | a | blue | spark | within | Left | Gas |
| ||||||
| Collector |
| Box. | if | a | spark is | present | the | ||||||
| Electrode | Tips | are | properly | positioned. | |||||||||
[] | if | no | spark | is | seen, |
| the | Spark | Gap | |||||
| needs |
| to | be | adjusted | as | follows: |
| ||||||
•Using an adjustable wrench, loosen the inside Nut until the Gas Collector Box can
be turned upward.
•if the gap between the Spark
Electrode Tip and Receiver is more than 3/16" use long nose pliers to
gently squeeze the Gas Collector Box to narrow the gap.
•Return the Gas Collector Box to its original position, secure the inside Nut and try the Electrode Check again, if no "clicking" sound is heard:
-AA Battery may be installed back-
-wards. Electric wires may be loose. Remove the AA Battery and inspect the ignitor Junction Box found behind
the Control Panel and reconnect any loose wires.
Side Burner Electrode Check
[] Open the Side Burner Lid and remove the plastic shipping band from the burner and the pot support.
[] Be sure Control Knob is set to "OFF" and open the Side Burner Lid. Press the Ignitor
Cap. You should hear a "clicking" sound
and see a blue spark between the tip of the
electrode and burner.
[] If you don't see a spark from the side burner electrode, adjust gap between electrode and burner surface to 3/16 inches.
Install Cooking Components
[] Place the Savor Plates ® (holes face rear of bowl) on lower ledge above Burners.
[] Place Cooking Grids on bowl ledge.
[] Place the Secondary Cooking Rack into the slots on Grill Bowl Side Panels.
SECONDARY
COOKING RACK
Model 141.16322
SLOTS FOR SECONDARY
COOKING RACK
Model 141.16324
When you have finished assembling your grill be sure that all screws are tightened for safe operation of your grill.
Failure to read and follow the Use and Care
Instructions could result in a fire or explosion that could cause serious bodilyinjury, death or property damage.
16
