Grill Lighting Instructions
1.Before each use, check all hoses for cracks, nicks, cuts, burns or abrasions. If a hose is damaged in any way, do not use your grill before replacing the hose with an authorized part from the Parts List. Also make
sure all gas supply connections are securely tight- ened.
2.Familiarize yourself with the safety and Use and Care
instructions in this manual. Do not smoke while lighting grill or checking gas supply connections.
3.Be sure the LP Gas tank is filled.
4.Open the Grill Lid.
5.Check that the end of each Burner Tube is properly located over each Valve Orifice.
Failure to replace a faulty hose, secure gas supply
connections or to open the Lid before proceeding
to the Lighting Procedures could result in a fire or explosion that could cause serious bodily injury, death, or property damage.
6.Set Control Knobs to OFF and open the LP Gas tank valve SLOWLY 1/4 of a turn.
I
OFF
Open LP Gas_
_-
7.Push and turn the Left Control Knob to HIGH.
HIGH MED
OFF _ | LOW |
8. Immediately press the Electric Ignitor for
If ignition does not occur in 5 seconds, turn the burner Control Knob(s) and gas source OFF and
conduct a leak test of ALL gas connections and
gas sources as explained in the Use and Care section of this manual. If no leaks are detected,
wait 5 minutes for any gas to clear and repeat the lighting procedure.
PRESS
9.After the Burner is lit, turn the tank valve SLOWLY one more 1/4 of a turn for 1/2 of one complete turn.
Once Left Burner is lit, the right adjacent Burner(s) can be lit by turning its Control Knob to HIGH in sequence from left to right.
Side Burner Lighting Instructions
1.Follow steps 1 through 3 of the Grill Lighting Instructions.
2.Open Side Burner Lid.
3.Set Control Knob to OFF and open the LP Gas tank valve 1/4 ~ 1/2 turn SLOWLY.
Push and turn the Control Knob on Side Burner to HIGH.
Press the Electric ignitor for
5.If the burner does not light, turn the knob to OFF. Wait 5 minutes, then retry or light by using lighting stick with a match.
If ignition does not occur, turn the burner Control Knob and gas source OFF and conduct a leak test of
ALL gas connections and fuel sources. If no leaks are detected, wait 5 minutes for any gas to clear and repeat the lighting procedure.
Manually Lighting Your Grill By Paper Match
To light your gas grill by match, insert a match into the Lighting Stick and follow steps 1 through 6 of the Grill
Lighting Instructions. Then, light the match and place Lighting Stick through the Lighting Hole on the left side of the grill as shown below. Turn the nearest Control Knob to the HIGH setting to release gas. The Burner should light immediately.
HOLE
LIGHTINGI
LIGHTING/_
STICK
\
MATCH
Never lean over the grill cooking area while lighting your gas grill. Keep your face and body a safe distance (at least 18 inches) from the Lighting Hole or Burners when lighting your grill by match.
2O
