Install Side Burner Kit
[] Insert the Side burner Gas Valve Assembly into Side Burner Tube (See Figure 1). Be sure the orifice is inside the Burner Tube properly (see warning on Page 3), or lighting the burner may
cause explosion and/or fire.
[] Insert the Side Burner Gas Valve Assembly through the Side Burner Gas Valve Hole on the Side Burner Frame. Align the 2 holes on the Side Burner Frame with the threaded holes on the Side Burner Gas Valve Bracket. Then insert the two (2) screws and washers provided and tighten securely.
[] Fasten the Control Knob onto the Side Burner
Gas Valve Stem. Be sure that the OFF position faces the Burner.
[] Connect the Electric Wire terminal from Side Burner with the other from Grill Head as shown.
Bind the connected Electric Wire and Side
Burner Connection Tube together using the
supplied Fastening Band.(Note: located in Operator's Manual plastic bag).
[] The gap between the Side Burner Electrode Tip
and the Side Burner Port should be
approximately 1/8"~ 3/16". If the gap is wider than 3/16", use a pair of long nose pliers and gently bend the Electrode Tip toward the burner.
[] Cut and remove Fastening Band from Side
Burner and Pot Support before use.
Side Burner Pot Support
[] Place the Side Burner Pot Support into the Side Burner Frame.
[] Place the Side Burner Wind Shield on the Side Burner Frame.
Pattern Head Screw M4x8mm
Qty. 2
Part # $132M04082
©
Plain | Washer M4 |
Qty. | 2 |
Part | # S411M04122 |
Control Knob for Side Burner
Qty. 1
Part # P03426083H
Scale 1:2
Figure
Electrical connection
1/8.~3/16.BURNER PORT
Fastening Band
Qty. 1
15
