Kenmore 141.16322, 141.16324 manual Check all connections for LP Gas Leaks

LP Gas Model only:

Connect Regulator with Hose to your LP Gas Tank

[]

Turn

all

Burner

Valves

to the

OFF

position.

[]

Inspect

the

valve

connection

port

and

regulator

assembly for damage or debris. Remove any debris.

Never

use

damaged

or

plugged

equipment.

[]

Connect

the

regulator

assembly

to

the

tank

valve

and

HAND

TIGHTEN

nut

clockwise

to

a full

stop.

DO NOT use a wrench to tighten because it could

damage

the

Quick

Coupling

Nut

and

result

in a

hazardous

condition.

[]

Open

the tank

valve

1/4

to

1/2

(counterclockwise)

turn and use a soapy water solution to check all

connections

for

leaks

before

attempting

to light your

grill.

See

"Checking

for

LP

Gas

Leaks".

If a

leak

is found, turn the tank valve off and do not use your

grill

until

the

leak

is

repaired.

Check all connections for LP Gas Leaks

Never test for leaks with a flame. Prior to first use, at the beginning of each season, or every time your LP Gas tank is changed, you must check for gas leaks. Follow these three steps:

[] Make a soap solution by mixing one part liquid

detergent and one part water.

[] Turn the grill Control Knobs to the full OFF position, then turn the gas ON at source.

[] Apply the soap solution to all gas connections

indicated by the arrows. See diagram. If bubbles appear in the soap solution the

connections are not properly sealed. Check each fitting and tighten or repair as necessary.

_ Gas Vatv_ / Manifold Assembly

TYNPsl121.n5ZbC_t_°002per

Quick

Coupling Nut

CAUTION: When the appliance is not in use the gas must be turned off at the tank.

Regulator with Hose (LPG)

Before

using

this

gas

appliance

read

all

If you have a

gas

leak that

cannot be

repaired

by

instructions

and

perform

all

gas

leak-check

tightening,

turn

off

the

gas

at

the

source,

disconnect

procedures

even

if

the

product

was

fuel

line

from

your

grill

and

call

1-8O0-4-MY-HOME

e_

pre-assembled

by the retailer

or manufacturer.

or

your

gas

supplier

for

repair

assistance.

Never disconnect the gas regulator or any gas fitting while your grill is lit. A lit grill can ignite leaking gas and cause a fire or explosion which

could result in property damage, personal injury or death.

Disconnecting A Liquid Propane Gas (LPG)

Tank From Your Grill

[] Make sure the Burner Valves and LP Gas tank valve

are off. (Turn clockwise to close.)

[] Detach the hose and regulator assembly from the LP Gas tank valve by turning the Quick Coupling Nut counterclockwise.

19