Ignitor Battery Installation - See Fig. 6
1.Unscrew the Ignitor Cap located on the Heater Head Assembly and remove the Con- tact and Spring from the Ignitor Slot.
2.Place the supplied AA battery into the Ignitor Slot with the positive pole facing outward.
See Fig. 6.
ASSEMBLY
1 5 V BATTERY (AA size)
IcGANpIT O'_.. | __ | "_ |
CONTACT | SPRING | IGNITOR SLOT |
Place the Spring over the AA battery, then place the Contact on top of the Spring. Screw the Ignitor Cap back onto the Heater Head Assembly. See Fig. 6.
Connecting A Liquid Propane Gas (LP gas) Tank To Your Patio Heater
1.Raise LP Tank Cover and unhook the safety chain. Place your filled gas tank on the Weighted Base. Hang the Safety Chain on the Hooks of both Legs using the chain links which hold your tank most securely. See Fig.
7.Make sure the LP gas tank valve is in the full OFF position. (Turn clockwise to close.)
NOTE: When connecting the LP gas tank, position the tank so its Hose and Regulator does not interfere or rub against the Tank Cover which will be raised and lowered often, possibly causing damage to the hose.
Figure 7 TYPE 1 TANK
CONNECTION DEVICE
REGULATOR
LP GAS TANK
(not included)
QUICK
COUPLING
NUT
CAUTION: When the patio heater is not in use, the gas must be turned off at the supply tank.
. Check the tank valve feature to ensure it has proper external mating threads to fit the Hose and Regulator Assembly provided. (Type 1 connection per ANSI
. Make sure the Burner Valve is in the OFF position.
. Inspect the valve connection port and Regula- tor Assembly. Remove any debris and inspect hose for damage. Never attempt to use damaged or plugged equipment.
. When connecting the Hose and Regulator Assembly to the tank valve, hand tighten nut clockwise to a full stop. Do Not use a wrench to tighten because it could damage the Quick Coupling Nut and result in a hazardous condition.
. Open the tank valve fully (counterclockwise). Use a soapy water solution to check all
connections for leaks before attempting to
use your patio heater. If bubbles appear in the soap solution the connections are not properly sealed. Check each fitting and tighten or repair as necessary.
If you have a gas leak that cannot be repaired
by tightening, turn off the gas at the source,
disconnect fuel line from your patio heater and
call
Disconnecting A Liquid Propane Gas (LP gas) Tank From Your Patio Heater
1.Turn the Burner Valve and LP gas tank valve to the full OFF position. (Turn clockwise to close.)
2.Detach the Hose and Regulator Assembly from the LP gas tank valve by turning the Quick Coupling Nut counterclockwise.
Congratulations
Your Kenmore Patio Heater is now ready for use. Before the first use and at the begin- ning of each season (and whenever the LP gas tank has been changed):
1.Read all safety, lighting and operating instructions.
2.Check Gas Valve Orifices, Burner Tubes and Burner Ports for any obstructions.
3.Perform Gas Leak Check according to instructions found on page 13 of this manual.
12
