OPERATING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or |
|
explosion may result causing property damage, personal injury |
|
or loss of life. | FLAMMABLE |
BEFORE OPERATING: ENTIRE SYSTEM MUST BE FILLED WITH WATER AND AIR PURGED FROM ALL LINES.
A.This appliance does not have a pilot. It is equipped with an ignitiion device which automatically lights the burner. Do not try to light the burner by hand.
B.BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS: 
Do not try to light any appliance. 
Do not touch any electric switch;
do not use any phone in your building.
Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
If you cannot reach your gas supplier, call the fire department.
C.Use only your hand to push in the gas control but- tons. Never use tools. If the control buttons will not push in, don't try to repair them, call a qualified ser- vice technician. Force or attempted repair may result in a fire or explosion.
D.Do not use this appliance if any part has been under water. Immediately contact a qualified installer or service agency to replace a flooded water heater. Do not attempt to repair the unit.
It must be replaced!
OPERATING INSTRUCTIONS
VACATION |
|
|
|
WARM | A | B | C VERY |
|
| HOT | |
COOLER |
| HOTTER | |
|
| ||
| |||
* |
| ||
* |
| ||
* |
| ||
| |||
1.STOP! Read the safety information above on this label.
2.Set the ON/OFF switch on the control box to the "ON" position.
3.Set the thermostat to the lowest setting by first
pressing the COOLER 
and HOTTER 
but- tons together and holding for 1 second. Then press the COOLER button 
until the Warm indicator light appears.
4.Set the ON/OFF switch on the control box to the "OFF" position.
5.This appliance is equipped with a device which automatically lights the burner.
DO NOT TRY TO LIGHT THE BURNER BY HAND.
6. Wait five (5) minutes to |
| clear out any gas. |
| ||
If you then smell gas, |
| STOP! Follow "B" in |
|
the safety information above on this label. If you don't smell gas, go to the next step.
7.Turn on all electrical power to the appliance.
8.Set the ON/OFF switch on the control box to the "ON" postition.
9.Set the thermostat to the desired setting by first
pressing the COOLER 
and HOTTER 
but- tons together and holding for 1 second. Then press the HOTTER button 
10.WATER TEMPERATURE ADJUSTMENT 
is approximately 120oF.
CAUTION: Hotter water increases the risk of scald injury. Consult the instruction manual before changing temperature.
11.If the appliance will not operate, follow the instruc- tions "TO TURN OFF GAS TO APPLIANCE" and call your technician or gas supplier.
WARNING: TURN OFF ALL ELECTRIC POWER BEFORE SERVICING.
TO TURN OFF GAS TO APPLIANCE
1.Set the thermostat to the lowest setting by first
pressing the COOLER 
and HOTTER 
but- tons together and holding for 1 second. Then press the COOLER button 
until the Warm indicator light appears.
2.Set the ON/OFF switch on the control box to the "OFF" postition.
3.Turn off all electrical power to the appliance if service is to be performed.
23
