ICE MAKER SAFETY
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING." These words mean:
You can be killed or seriously injured if you don'timmediately follow instructions.
You can be killed or seriously injured if you don't follow instructions.
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed.
|
|
|
| IMPORTANT | SAFETY INSTRUCTIONS |
|
|
|
|
| ||||
WARNING: | To reduce | the | risk of fire, electric | shock, or injury when | using your | ice | maker, | follow these | basic | |||||
precautions: |
|
|
|
|
|
|
|
|
|
|
|
|
| |
• | Plug into | a grounded 3 prong | outlet. | • | Disconnect | power | before | cleaning. |
|
| ||||
• | Do not remove ground | prong. |
| • | Disconnect | power | before | servicing. |
| |||||
• | Do not use an adapter. |
|
| • | Replace | all parts | and | panels | before operating. |
| ||||
• | Do not use an extension | cord. |
|
| ||||||||||
| • | Use two | or more | people | to | move | and install ice | maker. | ||||||
|
|
|
|
| ||||||||||
SAVE THESE INSTRUCTIONS
INSTALLATION INSTRUCTIONS
Excessive Weight Hazard
Use two or more people to move and install ice maker. Failure to do so can result in back or other injury.
Removing Packaging Materials
Remove tape and glue from your ice maker before using.
•To remove any remaining tape or glue, rub the area briskly with your thumb. Tape or glue residue can also be easily removed by rubbing a small amount of liquid dish soap over the adhesive with your fingers. Wipe with warm water
and dry.
•Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue. These products can damage the surface of your ice maker.
Cleaning Before Use
After you remove all of the packaging materials, clean the inside of your ice maker before using it. See the cleaning instructions in the Ice Maker Care section.
To ensure proper ventilation for your ice maker, the front side must be completely unobstructed. The unit may be
Installation of the ice maker requires a cold water supply inlet of 1/4"(6.35 mm) OD soft copper tubing with a shutoff valve and either a
Choose a well ventilated area with temperatures above 55°F (13°C) and below 100°F (38°C). Best results are obtained between 70°F (21 °C) and 90°F (32°C).
This unit must be installed in an area protected from the elements, such as wind, rain, water spray, or drip.
