1_<_ Firmly
E} Seated
Media
Motor Panel
_Reservoir Divider
Fig, 22
10.Remove the quick disconnect socket, brass compression nut, and brass sleeve from hardware bag (Fig. 23). With water supply tubing cut to the proper length, slide the brass compression nut and sleeve over the tubing as described in Step 5, Page 10. Slip the brass insert into the end of
11.Insert the tubing end into the quick disconnect socket as far as it will go and hold it there. Thread the brass compression nut onto the quick dis- connect socket, then tighten using two wrenches, one to hold quick disconnect socket and one to tighten nut. Do not
Nut
QUICK DISCONNECT
ASSEMBLY
| Sleeve |
|
| insert |
|
"Quick Disconnect |
| |
Socket | 1/4" | Plastic |
| ||
| Water | Supply |
| Tubing | |
Fig, 23
12.Connect the quick disconnect socket to the plug on the valve body (Fig. 24).
Sleeve
/
... _ Humidifier
Fig, 24
To connect, pull back sleeve, push socket onto plug, release sleeve.
To disconnect, pull back sleeve, unlocking quick disconnect and sealing water supply line, separate from the plug.
13.It is best to install an overflow line. Local
building codes may require it. The overflow hole is in the bottom left front corner of the reservoir
(Fig. 20). Use 1/2" inner diameter rubber or plas- tic tubing to connect to drain. (Tubing not sup- plied. Purchase at your local hardware store.)
11
