Kenmore 318205342A manual To Start the Self-Clean Cycle, When the Self-Clean Cycle is Completed

Self-Cleaning

To Start the Self-Clean Cycle

The CLEAN pad controls the Self-Cleaning feature. If you are planning to use the oven directly after a self-clean cycle remember to allow time for the oven to cool down and the oven door to unlock. This normally takes about one hour. So a 3 hour self-clean cycle will actually take about 4 hours to complete.

*It is recommend to use a 2 hour self-clean cycle for light soils, a 3 hour cycle for average soils, and a 4 hour cycle for heavy soils (to assure satisfactory results)

CAUTION To avoid possible burns use care when opening the oven door after the Self- Cleaning cycle. Stand to the side of the oven when opening the door to allow hot air or steam to escape.

CAUTION DO NOT force the oven door open. This can damage the automatic door locking system. Use caution and avoid possible burns when opening the door after the Self-Cleaning cycle has completed. The oven may still be VERY HOT.

		Instructions	PRESS	DISPLAY
To start an immediate Self-Cleaning cycle or to set a Delay
Start time of 4:30 and shut-off automatically (example
provided is a default 3 hour Self-Clean Cycle)				Fig. 1
1.	Be sure the clock is set with the correct time of day and the oven
	door is closed.
2.	Press	.
3.	Press	. "UPPER" and "CLEAN" will flash and "3:00 HR" will		Fig. 2
	show in the display (Fig. 1). The control will automatically clean
	for a 3 hour period (default self-cleaning cycle time). Note: If a 2
	or 4 hour clean time is desired, press 2 0 0 for 2 hour or press		2 0 0 or
	4 0 0 for a 4 hour clean time. Set the cleaning time based on		4 0 0	Fig. 3
	the amount of soil: light, medium or heavy (* See above).
4.	Press	. The "DOOR LOCKED" icon will flash; "UPPER",
	"CLEAN" icon and the letters "CLn" will remain on in the display			Fig. 4
	(Fig. 2).
5.	As soon as the control is set, the motor driven oven door lock will
	begin to close automatically. Once the door has been locked the
	"DOOR LOCKED" indicator light will stop flashing and remain on.			Fig. 5
	Also, the oven icon will appear in the display (Fig. 3).
Note: Allow about 15 seconds for the oven door to lock.
Note: If the optional delay Self-Clean feature is desired, finish step
6-9. If Self-Clean is started immediately skip the remaining steps				Fig. 6
and continue with “When the Self-Clean cycle is done” on the
following page.
6.	Press	(Fig. 4). Enter the desired start time using the number
	pads 4 3 0 (Fig. 5).		4 3 0
7.	Press	. "CLEAN", "DELAY", "LOCK", "UPPER" and "DOOR"
	will be displayed (Fig. 6).

9.The control will start the self-cleaning at the set start time, for the period of time previously selected. At that time, the icon "DELAY" will go out.

When the Self-Clean Cycle is Completed

1. “HOT” will appear in the display. The time of day, the "DOOR LOCKED" and "CLEAN" icon will remain in the display.

2. Once the oven has cooled down for approximately 1 HOUR, and the "DOOR LOCKED" icon is no longer displayed, the oven door

can then be opened.

28