LAUNDRY TUB DRAIN SYSTEM

Check location where washer will be installed. This washer can be installed

using one of three systems:

Laundry tub drain system (below)

Standpipe drain system (p. 12)

Floor drain system (p. 12)

Do not store or operate washer at or below 32°F (some water may remain in washer). See page 31 for Winterizing Information.

Proper installation is your responsibility. Make sure you have everything necessary

for correct installation including the following points:

Grounded receptacle: Must be within 4 feet of where the

power cord is attached to the back of the washer.

Hot and cold water faucets: Must provide water pressure between 5-100 psi and be within 4 feet of the hot and cold water fill valves attached to the back of the washer.

Laundry tub drain system: Needs a minimum 20-gallon laundry tub.

Support: Floor must be sturdy enough to support a total weight of 315 pounds (including washer, water, and load weight).

Level floor: Maximum

allowable slope under entire washer- I inch.

Top of tub must be at least 39 inches above

floor and no higher than 96 inches from bottom of washer.

I1

Page 11
Image 11
Kenmore 3950144 owner manual Laundry TUB Drain System