Kenmore 505, 305 owner manual Guidelines

Set dip switches 2 and 3 to the values shown in table below for your altitude. The default setting for the appliance is 0-2000 ft (0-610 m) with switches No. 2 and No. 3 in the OFF position.

DO NOT adjust the other dip switches unless specifically instructed to do so.

	0-2000	ft	2001-5200 ft		5201-7700	ft	7701-10200		ft
Table 4:	(0-610	m)	(610-1585	m)	(1585-2377	m)	(2378-3109		m)
Switch No. 2	OFF		OFF		ON			ON
Switch No. 3	OFF		ON		OFF			ON
	Switch	No.	Switch No.		Switch No.		Switch No.
	ON		ON		ON			ON
	O	1	O	1	O	1	O	1
		2	Fm				F
					m	2	F	•2
		3	m	3	•	3		•3
		4		4		4		4
		5		5		5		5
		6		6		6		6
		7		7		7		7
		8		8		8		8

The 2-Unit connection cable is an optional accessory that connects 2 water heaters and allows them to

function as one hot water source.

The Multi-Unit connection kit and Multi-Unit connection

cables are optional accessories that connect 2 to 5 water heaters and allow them to function as one hot

water source.

The Multi-Unit connection kit includes a PC board and one Multi-Unit connection cable.

Refer to the instructions that come with the accessory for complete installation information.

Guidelines

•Do not install both the 2-Unit connection cable and the Multi-Unit connection kit because they are not designed to operate together.

•Water heaters should be installed less than 18 inches apart so that the cables will reach between units and to prevent temperature fluctuations (cold water sandwich effect) when the water is shut off and turned back on.

•Temperature settings can only be changed on the controller for the primary unit.

Table 5:
Number of Connected Water Heaters:			Accessories Necessary:
2		(1) 2-Unit	connection	cable or (1) Multi-Unit		connection	kit
3	(1) Multi-Unit		connection	kit and (1) Multi-Unit		connection	cable
4	(1)	Multi-Unit	connection	kit and (2)	Multi-Unit	connection	cables
5	(1)	Multi-Unit	connection	kit and (3)	Multi-Unit	connection	cables

20 305 & 505 Outdoor Manual