Kenmore 596.50019100 manual Hints and Care, How to Remove and Replace Light Bulbs, Freezer Section

Hints and Care

How to Get the

Most Out of

Your Energy

Dollar

•Avoid overcrowding refrigerator shelves This reduces effectivity of air circulation around food and

causes refrigerator to run longer

•Avoid adding too much warm food to unit at one time, This overloads

compartments and slows rate of cooling

•Do not use aluminum foil, wax

paper, or paper toweling as shelf liners This decreases air flow and

causes unit to run less efficiently

•A freezer that is 21afu{t runs most efficientfy

•Locate refrigerator in coolest part of room, Avoid areas of direct sunlight, or near heating ducts, registers, or other heat producing appliances If this is not possible, isolate exterior by using a section of cabinet or an added layer of insulation

•Refer to this Use and Care Guide

section on temperature controls for

recommended control settings

m Clean door gaskets every three months according to this Use and

Care Guide's cleaning instructions This wilt assure that door seals

property and unit runs efficiently

•Take time to organize items in refrigerator to reduce time that door is open.

. Be sure your doors are closing secure{y by feveling unit as" instructed in this Use and Care Guide,

•Clean condenser coils as indicated

in the Use and Care Guide every 3 months This will increase energy efficiency and cooling performance,

How to Remove and Replace Light Bulbs

[ WARNING I

To avoid electrical shock which can cause severe personal injury or death, disconnect power to refrigerator before replacing Iight bulb After replacing tight bulb, connect power

[CAUTION]

To avoid personal injury or property damage, observe the following:

•Allow light bulb to coot

•Wear gloves when replacing light bulb

Upper refrigerator section

1, Locate finger gaps on each side of clear light _"-'_o_T_

shield Insert fingers and press in on each side of shield Pull shield down and remove

2, Remove light bulbs

3, Replace with appliance bulbs no greater than 40 watts.

4Replace light bulb cover by inserting front tabs of (.-_r,'r "t _.__/ light shield into slots direcUy in fronl of light assembly,

.w Jl ,=d

n i nUllllln,,u,,

Lower refrigerator section

Pinch bottom tabs (A) on light cover and pull straight out

2 Remove light bulb,

3.Replace butb with appliance bulb no greater than 40 watts.

4	Insert top tabs			(13) of tight cover into liner slots and
	snap bottom portion over Iight assemb{y									A
									i	i innnnn, n u n n lUn,u i ,nl ii, ,,,,i,u,,,,u,,i
1,	Remove	ice	bin by			tifting front	of bin and puiting out			.._i_---.....,
2	Remove	lightbulb cover by pinchingtop tab (A) and I!"_								_	_h_'_I
	pulling	cover		out,					V.t::_I\	_	/1_=_
3	Remove	tight		bulb		Replace	with appliance	butb	{_V	k-_
	no greater		than		40	wafts.			".-._v.._.7
4-	Insert bottom			tab	(13) of light		cover into liner	slots	and snap	A
" Freezer		section

top portion over light assembly

5.Repface ice bin by sliding in until bin locks into piece