INSTALLATION STEPS (cont.)
WATER FILTER HOUSING UNDERSINK, TO FILTER WATER TO 1 FAUCET
REFER TO FIG. 4, PAGE 5. If optional kits are used follow instructions included with them
1.Close the cold water side shutoff valve Usually there already is a shutoff under the sink If not close the main water shutoff valve near the water meter or pressure tank
2.Cut and remove a section of the cold water pipe
3.If plumbing with flexible tubing hang or support the filter housing in some manner the optional mounting bracket is preferred If using rigid pipe be sure to allow a minimum of 11/2" clearance under the filter for sump removal when changing the filter cartridge
4.Use the plumbing procedures on page 6 if using compression fittings Follow procedures on pages 6 and 7 for sweat copper and threaded pipe installation Be sure water flow is into the filter inlet side, and from the outlet side to the faucet
Note: A grounding jumper wire is not required
5.Before turning on the water supply, remove the sump from the filter head and install the filter cartridge see below
FILTER CARTRIDGE INSTALLATION
TURN TO PAGE 9 AND FOLLOW ALL STEPS UNDER ``FILTER CARTRIDGE REPLACEMENT
8