Kenmore 625.348261 owner manual Uu U, iltltl, How Your Water Filter Works, I !I

I SECTION2 HOW YOUR WATER FILTER WORKS

A. FACEPLATE TIMER FEATURES

The default settings for fill (6:00 minutes), brine

draw (80 minutes), backwash (12 minutes) and

fast rinse (8 minutes) cycles of regeneration are

factory set for maximum performance of the filter.

Use the following procedures to check for correct

cycle times, or to change if desired. However, only

trained technicians should change the time set- tings.

FILL

Press and hold the SELECT button until the dis- play shows "000- -", then press the SELECT but- ton once to display the Fill time screen.

This setting should stay at the 6:00 minute fill time.

ADJUSTABLE BRINE DRAW

Press and hold the SELECT button until the dis- play shows "000- -", then press the SELECT but-

ton twice to advance to the Brine Draw time adjust screen.

Using the UP or DOWN buttons, adjust the back-

wash time from 0 minutes to 60 minutes.

ADJUSTABLE FAST RINSE

Press and hold the SELECT button until the dis-

play shows "000- -", then press the SELECT but-

ton four times to advance to the Fast Rinse time

adjust screen.

I	I	0
I_!I_I !_!	t !	O
	[	TIME

Using the UP or DOWN buttons, adjust the fast

rinse time from 0 minutes to 60 minutes.

TIMER "POWER- OUTAGE MEMORY"

If electrical power to the timer is interrupted, the

"memory" built into timer circuitry keeps time for

6 hours (nlinilnum) or more. The display is blank

and the filter will not regenerate. When electrical

power comes on, one of two things will happen.

Using the UP or DOWN buttons, adjust the brine

draw time from 0 minutes to 255 minutes.

ADJUSTABLE BACKWASH

Press and hold the SELECT button until the dis-

play shows "000- -", then press the SELECT but-

ton three times to advance to the Backwash time adjust screen.

1.The present time of day will show steady,

meaning the timer has not lost time.

2.The display will show a time, but it will be flashing. The timer memory did not keep the time setting and must be reset (page 1-3). If

you do not reset the time, regenerations will most likely be at the wrong time of day.

i'ltltl

I__'! II--

NOTE: The flashing display is to remind you to reset the timer.

UU U " "

TIME

2-2

NOTE: If the filter was in a recharge when power

was lost, it will now finish the cycle.

Problems, Questions? Call 1-800-426-9345 Kenmore Water Line