Kenmore 625.38827, 625.38826 Maximum Days Between REGENERA- Tions and 12 / 24 Hour Clock

A. FACEPLATE TIMER FEATURES

_1_ OPTIONAL SETTINGS - SALT EFFICIENCY,

CLEAN FEATURE, CLEAN FEATURE MINUTES,

MAXIMUM DAYS BETWEEN REGENERA- TIONS and 12 / 24 HOUR CLOCK:

1.To set any of the following options, press and hold SELECT for 3 seconds until 000 shows in the display.

Then press once until the SALT EFFICIENCY dis-

play shows. Use the UP / Down buttons to change the ON / OFF displays.

OFF

o

_SALTEFFICIENCY'OWhen this feature is ON, the unit will operate at salt efficiencies of 4000 grains

of hardness per pound of salt or higher, which will reduce the softeners salt usage. (May recharge more often using smaller salt dosage and less water).

2. Press SELECT again to show the CLEAN display.

UFF

_CLEAN: This feature is beneficial on water sup-

plies containing iron and/or high amounts of sedi- ments (sand, silt, dirt, etc.). When set to ON, a back- wash and fast rinse cycle will occur first, preceeding

the normal regeneration sequence (see page 2-4).

This provides extra cleaning of the resin bed before

it is regenerated with the salt brine. To conserve wa-

ter, if your water supply does not contain iron or

sediments, be sure this feature is set to OFF.

3.Press SELECT again until the CLEAN TIME dis- play shows.

_es example: time set to 3 minutes

_CLEANfeature minutes: If you are using this fea-

ture, the length of the extra backwash cycle auto-

matically sets to 7 (9minutes on UltraSoft 250) min-

utes. However, you can adjust this time from I to 15

minutes in length. To change this cycle time, use the UP button to increase the time, or the DOWN button

to shorten the time. If no change is desired, continue below.

2-2

4.Press SELECT again to show the following RE-

CHARGE display.

RECHARG£_t

default display	example: set to	4 days maxi-
	mum between	regenerations

_Maximum days between regenerations: The face-

plate timer automatically controls regeneration fre-

quency (see page 2-5). This provides the greatest operating efficiency, and under most conditions this

feature will be left in its default mode. However, you can modify this feature if you want to force a

regeneration every set number of days. For exam-

ple, if your water supply contains iron and you

want the softener to regenerate at least once every few days to keep the resin bed clean, set the display as typically shown above. Setting is available from 1 to 15 days by using the UP and DOWN buttons.

5.Press SELECT to show the 12 HOUR display.

_12	or	24	hour	clock:	All	time	I	J
displays		are shown in			standard
clock	time		(1 to	12 PM;	and	1 to
12 AM) at the 12 hr default set-
ting. If military time displays are
desired,		set to 24 hr by			pressing			riME
the UP		button.

6.Press SELECT to return to the present time dis- play.

WATER FLOW THROUGH THE SOFTENER

If soft water is in use, the water

flow bars continually scroll

across the display. The bars scroll slowly when water flow is slow, and move faster as water flow increases. The flow bars do not show when all faucets and

water using appliances are off.

=i 2,3B"

Flow bars scroll when I_,; { _LQ"_ _"

SOft water is in use _==1,:_

Problems, Questions? Call 1- 800- 426- 9345 Kenmore Water Line