Kenmore 625.38826 Recharge Time Remaining and Valve, Position Indicators, Minutes, Error Code

_._-_-_,_,_,.!_SECTION' : 2 _,_J

HOW YOUR WATER SOFTENER WORKS

• RECHARGE TIME REMAINING and VALVE

POSITION INDICATORS

One	of the valve positionindi-							valve		recharge
								position		time
cators		(Serv,	Fill,		Brine,			indicators		remaining
while the softener is recharg-
ing	(See	*Note	on page		2-1		if	J
the	CLEAN		feature	is		ON).				°
RECHARGE			flashes		in	the
display		and,	beginning		with		Brine,		the minutes		of
recharge		remaining		before		return		to	service appears

correct time for about 12 hours. When electrical power comes on again, you have to reset the present time only if the display is flashing. The HARDNESS

and RECHARGE TIME never require resetting un-

less a change is desired.Even if the timer is incorrect after a long power outage, the softener works as it

should to keep your water soft. However, regenera- tions may occur at the wrong time of day until you reset the timer to the correct time of day (page 1-3).

in place of the present time. When the valve is mov- ing from one cycle to another, both position indica- tors are flashing.

• PROGRAM MEMORY

If electrical power to the softener goes off, the time display is blank but the face plate timer keeps the

•ERROR CODE

An error code could appear in

the face plate display if a prob-

lem occurs in the softener elec- tronics. Turn to page 5-2 under

"Troubleshooting" to resolve the problem.

E

I-I- [

2-3

Problems, Questions? Call 1-800-426-9345 Kenmore Water Line