Kenmore 665.1301 manual Troubleshooting

TROUBLESHOOTING

CHECK THESE POINTS TO HELP SAVE YOU TIME AND MONEY.

PROBLEMSOLUTION

DISHWASHER DOES	NOTE: It is normal for the dishwasher to repeatedly pause several times during a cycle.
NOT RUN	If the Start/Resume light is blinking, close the door and push START/RESUME.
	Be sure the door is closed and latched.
	Check that there is not an interference with large casserole dishes and the wash system at
	the back of the dishwasher. Adjust loading as necessary to ensure door is closed and
	latched.
	Be sure you have selected a cycle. (See “Cycles and Options Information.”)
	Be sure there is power to the dishwasher. A circuit breaker or fuse may have tripped.
	If lights other than Start/Resume blink and the unit will not run, you will need to call for
	service.
DETERGENT REMAINS IN	Check for dishware such as cookie sheets, cutting boards, or large containers, etc., that may
THE DISPENSER OR	be blocking the detergent dispenser from opening properly.
TABLET IS ON BOTTOM	Be sure your detergent is fresh and lump free.
OF TUB
	Be sure the cycle has completed (green or blue light is on). If it has not completed, you will
	need to resume the cycle by closing the door and pressing START/RESUME.

CYCLE RUNS TOO LONG	NOTES:
	■ To use less water and reduce energy consumption you will encounter cycles that
	typically run for up to 3 hours.
	■ A water heater setting of 120°F (49ºC) is best, the dishwasher will delay longer while
	heating cooler water.
	■ Some options will add time to the cycle. (See “Cycles and Options Information” section.)
	The Heated Dry option adds ½ hour.
	Try the 1 Hr Wash cycle.
	Run the hot water at a faucet close to the dishwasher before starting the cycle.
DISHWASHER NOT DRYING	NOTE: Plastic and items with nonstick surfaces are difficult to dry because they have a
	porous surface which tends to collect water droplets. Towel drying may be necessary.
	Use of rinse aid along with the Heated Dry option is needed for proper drying.
	Proper loading of items can affect drying. (See specific loading instructions within this
	guide.)
	Glasses and cups with concave bottoms hold water. This water may spill onto other items
	when unloading.
	■ Unload the bottom rack first.
	■ Locate these items on the more slanted side of the rack for improved results.
WILL NOT FILL	Be sure the water is turned on to the dishwasher.
	Check that the float is free from obstructions. (See “Parts and Features.”)
	Check for suds in the dishwasher. If foam or suds are detected, the dishwasher may not
	operate properly or may not fill with water.

21