Kenmore 665.1378 Loading Silverware Basket, Suggested 10 place setting loading patterns, A C B

Models: 665.1388 665.1378

1 24
Download 24 pages 62.03 Kb
Page 12
Image 12
Suggested 10 place setting loading patterns

Suggested 10 place setting loading patterns

TURBOZONE™ 10 place setting top rack load

TURBOZONE™ 10 place setting bottom rack load

Fold-down tines

You can fold down one row of tines at the back of the bottom rack.

1.Grasp the tip of the tine that is in the tine holder.

2.Gently pull the tine out of the tine holder.

3.Lay the row of tines down in the rack to make room for larger dishes, bowls, pots, pans or roasters.

Knife holder

Use the knife holder on the left side of the bottom rack to hold knives that are too large for the silverware basket. Place knives in the holder as shown.

To remove the knife holder

1.Slide up to release the hooks over the rack wire.

2.Lift knife holder out of rack.

To install the knife holder

1.Align the knife holder with the bottom rack as shown in the illustration below.

2.Place the bottom slotted guide over the vertical wire in the side of the rack.

3.Place the hooks, located on the back of the knife holder, over the center rack wire and gently push down to lock into place.

A

C

B

A. Top alignment

B. Bottom slotted guide

C. Knife holder hooks

Loading Silverware Basket

Load the silverware basket while it is in the bottom rack or take the basket out for loading on a counter or table.

NOTE: Unload or remove the basket before unloading the racks to avoid spilling water droplets onto the silverware.

Place small items such as baby bottle caps, jar lids, corncob holders, etc., in a covered section. Close the cover to hold small items in place.

Use suggested loading patterns, as shown, to increase washability of your silverware. Load items using the slots with the covers down to avoid silverware nesting.

This silverware basket can be separated and placed into the bottom rack in several locations. Load silverware in all sections or just one, depending upon your load.

If your silverware basket does not have covers or when covers are up, mix items in each section of the basket with some pointing up and some down to avoid nesting. Spray cannot reach nested items.

IMPORTANT: Always load items (knives, skewers, etc.) pointing down.

12

Page 12
Image 12
Kenmore 665.1378 Loading Silverware Basket, Suggested 10 place setting loading patterns, Fold-down tines, Knife holder