Kenmore 665.72002 manual To Install Starter and/or Bulb, Before Removing, To Remove

3.Push release lever toward bulb, The left end of the light assembly will raise up.

1 2 3

_-__-

/"_

__J/

I. Starter

2. Release lever

3.Bulb

4.To remove starter turn it counterclockwise and lift out of its mounting Base.

5.To remove bull roll it forward or backward 90 ° until it clicks then lift out

To Install Starter and/or Bulb:

1.Fit starter prongs into starter mounting base and turn clockwise,

Slide bulb 3rongs into bulb mounting 3ase ends. Roll the bulb forward or backward 90 ° until it clicks.

3.Push down on the left end of the bulb mounting base. When the assembly latches, it will CI_CK

4.Replace lens cover, Position the two rear lens cover tabs in front of the two metal spnng cl_ps {located d_rectly behind the bulb) Push back and down on the lens cover to lock into

DOSIDOn,

5.Plug in range or reconnect power.

For normal range use, it is not suggested to remove the oven

door. However.	if necessary,	follow these instructions. The oven
door is heavy	-

Before Removing:

1.Use a putty knife or screwdriver and insert it at the bottom corner of the door Stop clip

I

1

(I

I. Door Stop Clip

2, Pry door stop clip free and remove from front frame hinge slot. Take care not to scratch finish.

3.Repeat procedure for other door Stop CIiD

To Remove:

1.OPen the oven door, Insert door removal Dins _ncluded with your range nto both hinge hangers. Do not remove the Dins while the door is removed from the range.

\

\

\

1	\	i	""
2
		\

1, Removal pins 2. Hinge hanger

2, Carefully close the door until it rests against the door remora DINS,

3.Graso the door on the sides w_th your fingers on the front of the door and your thumbs on the inside surface.

4.Pull door straight up then toward you. Hinge hangers will slide out of front frame hinge slot. Do not remove aoo_ removal pins until the door is replaced on the range.

22