Kenmore 7146611 4D. CONNECT DRAIN HOSES, 2. , _1 IIII I1_

SECTION 4

STEP BY STEP GUIDES TO INSTALL

4D. CONNECT DRAIN HOSES

IFINSTALLING A CLARIFIER, NEUTRALIZER OR TASTE

& ODOR FILTER, SKIP PAGE 15 AND GO TO PAGE 16.

2. CONNECT THE BOTTLE DRAIN TUBING

AUTOMATIC IRON FILTER

Connect a length of 5/16" plastic tubing to the vent fitting

on the feeder valve (Figure 11) using a nut ferrule. Putthe

other end ofthe tubing over the drain and fasten it to the

valve drain hose so it stays over the drain. If a copper

drain is needed, get the tubing and fittings shown it Fig-

ure 11.

WARNING:

THIS DRAIN (VENT) MUST ALWAYS BE OPEN TO AL-

LOW AIR TO ENTER AND LEAVE THE BOTTLE. IF

PLUGGED, THE BOTTLE WILL COLLAPSE. IF THE

BOTTLE OVER FILLS, SOME POTASSIUM PERMAN-

GANATE SOLUTION COULD COME FROM FROM

THE DRAIN TUBING. BE SURETHE END OFTHETUB-

ING IS ALWAYS OVER THE DRAIN.

BOTTLE DRAIN TUBING, AUTOMATIC

IRON FILTER

_ 1d_._5/16"O.D. Tubing

_1 IIII I1_ _ straight

_1 IIII I_d_---- connector

COPPER

BOTTLE DRAIN

1/4"Copper (Hard

or Soft) Tubing

To Drain

Point

Compression

Adaptor