Replacement and Care
WARNING: To reduce the risk of shock or injury from moving parts, always unplug humidifier before removing or replacing any parts.
CAUTION: To help retard bacteria growth and keep maximum efficiency, the filter should be replaced at least once per season, or more often
under hard water conditions. Use Kenmore
replacement filter.
Replace the evaporative wicking filter at
least once per humidification season or more depending on water conditions in your area.
Filter Replacement
1.Unplug humidifier. Before removing
the filter, we recommend moving the humidifier to an area where floor
coverings are not susceptible to water damage. (i.e. kitchen or bath areas.)
2.Remove the water bottle and set aside. Be sure not to bump or damage the fill valve.
3.Grasp the housing assembly and lift
straight up and away from the base and set aside. The filter is now
accessible.
4.Take note of the filter position. Remove the filter. You may want to clean the base at this time. See the
"Cleaning Your Humidifier" section of this manual.
5.Install a new filter
between the uprights in the bottom of the base. The start and finish of the
coil should be captured at the center of the base (see diagram) and the filter should be resting on the floor of the base.
6.Return the housing assembly to the top of the base. Reposition the humidifier to its operating position.
7.The humidifier is now ready to be filled for operation.
of Filter --
Grasp housing
assembly
securely and
lift off .............
_ Position start and finish of
coiled filter at center of base
Align housing assembly bottom with top of base and reposition
curely
i0
