Kenmore 758.15408 manual Operating the Controls, To Operate the Controls

Step 4. Operating the Controls --

Where you set your desired humidity levels depends on your personal comfort

level, outside temperature and inside

temperature. A starting set point of 30% - 40% ROOM humidity is recommended

but there may be conditions that require a different setting.

IMPORTANT: Water damage may

result if condensation starts to form on windows or walls. Humidity SET

point should be lowered until

condensation no longer forms. We

recommend room humidity levels do not exceed 50%.

When Outdoor		Recommended indoor
Temperature is:		Relative Humidity is:
-10 ° F	-24 ° C	20%
2°F	-18°C	25%
10 ° F	-12 ° C	3O%
20 ° F•	_6° C•	35%

* and above

To Operate the Controls

Digital Display

Press the power button once to turn the unit on* _). initially there is a slight delay while the electronics calibrate.

Two bars (- -) appear during this time. Once calibration is complete a ROOM humidity reading between 20% - 95% will be displayed. A flashing 20 display indicates that the room humidity is less than 20%.

NOTE: The default settings at initial startup are (LOW) FI fan speed and 65% SET humidity. After desired settings are selected by the user, they remain as long as the unit remains plugged in and there

is no power interruption. If the unit is unplugged the original default settings are employed.

*Humidifier fan should operate at initial start up. If it does not, refer to, "Fan not operating (digital display is illuminated)" in the "Trouble Shooting" section on page !2 of this manual.

Function

Buttons

\

\

'Digital Display