Operating the Controls
Speed Button O
This humidifier is equipped with a 3- speed fan control. Initially depressing the speed button will display the current speed setting. Each push of the speed button advances the mode through the settings of (HIGH) F3, (MEDIUM) F2, (LOW} FI and (AUTO) A.
The selected setting is displayed on the digital readout. The higher the setting, the faster water is evaporated and released into the air. FI (LOW) is the quietest setting and is provided for conditions that
de not require a rapid evaporation rate. When (AUTO) A is selected the humidifier will determine the required fan speed needed to bring the actual room humidity up to the set humidity.
Speed Button ,,
'\
Using Your Humidifier
Refill Display
For maximum run time both the bottle and the base should be filled. When both the bottle and the base empties the display alternates the room humidity reading and "F" (FILL), informing additional water is required. Also at this
time the unit will automatically switch into DRY OUT MODE and continue to run on the lowest speed until the filter is dry.
(cont'd.) --
Humidity Control O
This button allows you to adjust the humidity to suit your needs. This humidifier
will automatically cycle on and off as required to maintain the selected setting. The readout displays both actual (ROOM) and desired (SET) humidity percentage
(%)settings when humidity control button is pressed. The ROOM readout has a range of 20% to 95%. if the room humidity
level is equal to or less than 20% the display will show a flashing 20.
The SET readout has a range of 25% to 65% and is adjusted in increments of 5%. initially depressing the humidity button will display the current humidity setting. Each additional press of the button increases the setting by 5%. A SET point of 65% operates the humidifier
continuously regardless of the ROOM reading. The humidistat that senses the
readings is located on the power cord. insure that it is free from obstruction.
Humidity Button,
1
Refill/Dry Out Mode
Display