Troubleshooting,
| Trouble |
|
| Probable | Cause |
| Remedy |
| ||
Digital | display not | illuminated. | • | No Power. |
| • Check | 120 volt power source. | |||
|
|
| • | Power | button has not been | • Press | power button | once to | ||
|
|
|
| depressed, |
| turn on. |
| |||
Fan not operating | (digital | • | ROOM | humidity | level is not | • Raise | SET humidity | level if | ||
display | is illuminated). |
| 3% or | more below SET | desired. |
| ||||
|
|
|
| humidity | level. |
|
|
|
| |
|
|
| • | Reservoir | is empty. | • Increase fan speed. |
| |||
|
|
|
|
|
|
|
| • Fill humidifier with water. | ||
Fan running continuously. | • | SET | humidity | level is 65%. |
| • | ROOM humidity level has not | ||
|
| reached 1% or more above | ||
|
| SET | humidity | level. |
•A SET humidity percentage of 65% operates fan
continuously. Adjust SET level between 25% - 60%.
•Continue to run until desired humidity level is achieved. This may take up to 48 hours initially.
Poor | evaporation of water. | • CHECK | FILTER message | ||||
|
|
|
| flashing, |
|
| |
|
|
| • Mineral buildup on filter. | ||||
Bottle | empties | completely. | • This is normal for initial filling. | ||||
Bottle | continues | to empty | • | Air is entering | water bottle. | ||
after | complete | filling. |
|
|
|
|
|
Bottle | not emptying. | • | Spring | Valve | Assembly | ||
|
|
|
| damaged | or missing post | ||
|
|
|
| in bottom | of base. | ||
• Base full of water.
•Change to a fresh new filter.
NOTE: Local water purity varies from area to area.
•Refill bottle for maximum run time.
•Check for leak in water bottle.
•Check orientation of bottle. Reposition so that fill valve on bottom of bottle is depressed by post in bottom of base.
•The base will hold the
contents of water bottle (1.2 gallons). Continue to run
humidifier to deplete water from base.
12
