Setting the Clock
Setting the Clock
The L--_ pad isused to set the clock. The clock may be set for 12 or 24 hour time of day
operation. The clock has been preset at the factory for the 12 hour operation. When the
range isfirst plugged in, or when the power supply to the range has been interrupted, the
timer inthe display will flash with "PF" (power failure, See Figure 1).
When PF appears inthe display, press _. A beep will sound and PF will disappear.
INSTRUCTIONS
To set the clock (example below for 1:30)
1. Press @. "CLO" willappear inthe display (Figure 2).
2. Press (_ (_ _ pads to set the time ofday to 1:30 (Figure
3).P tess ::iTARi:. The time ofday will appear inthe display(Figure
4).
Changing between 12 or 24 hour time of day display
1. Press and hold L-_ for7 seconds. "CLO" and the current time of
day will appear in the display (Figure 2). A beep will sound and
"12h" (Figure 5) or "24h" (Figure 6)will appear inthe display.
2. Press _n) to switch between the 12 and 24 hour time of day
display. The display will show either "12h" (Figure 5) or "24h"
(Figure 6).
3. Press : STAR_'_to accept the change or press _ to reject the
change.
4. Reset the correct time as described in To set the Clock above.
Please note that if the24 hour time of day mode was chosen, the
clock will now display time from 0:00 through 23:59 hours.
PRESS

@

QQQ

@

for 7seconds

@

:i!! or@
Figure 1
DISPLAY
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6